Installation Procedure

Follow our step-by-step guide

Outlet

Please confirm if there is an electrical outlet below the sink. Power-based installation is the most stable and secure, with a special power-saving mode for extended battery life.

Pull-out Faucet

This product is suitable for pull-out faucets, making it more convenient for kitchen use when cleaning the sink.

Pull-out Hose Diameter

Ensure that the diameter of the pull-out hose connector for the faucet is 4 points (DN15).

Water Saving Controller Kit

Once you have your DIY tool kit and foot-operated water saver kit ready, you can begin the installation process!

Controller Instructions

Right Side:

In/Out Water Connection Ports: Used to connect the pull-out hose.
Manual/Auto Switch: In case of a power outage, simply rotate the switch counterclockwise to the manual position to use the faucet switch for water supply.

Left Side:

Inlet Water Connection: The water hose connector has a diameter of 4分 (DN15), which is approximately 15mm in internal diameter. If the diameter does not match the pull-out hose, suitable adapters can be purchased at a hardware store.

Step 1

Turn off the water supply and install the check valve in the middle of the water hose and the water source after separating the water hose. Ensure that the rubber washer is present inside the check valve before installation. Tighten the check valve securely, but exercise caution not to over-tighten it, as it could damage the rubber sealing washer inside, causing blockages, low water pressure, or leakage.

Step 2

Please confirm that the inlet/outlet ends of the pull-out hose from the faucet are connected correctly to position 3 on the controller. Also, please check for any twisting or kinking of the hose.

Step 3

Ensure that the pull-out hose 2 is correctly connected to the inlet/outlet water connection ports on the controller 3.
Verify the connection of the cold/hot water hoses
Check all pipelines for kinks or twists.

Step 4

Place the foot pedal in the appropriate position. Thread it through the hole for the water pipe and connect it to the controller. (Refer to the controller instructions)
Connect the controller’s power cord.
Open the cold/hot water source valves on the kitchen wall and turn on the faucet.

Step 5

Check if the foot pedal switch operates correctly by lightly stepping on it to switch on the water (ensure it is in automatic mode).
Then, arrange all pipes neatly and securely position the controller.
Finally, check for any water leaks in the pipelines.

Step 6

Installation is now complete! You can begin enjoying the convenience of the foot-operated water-saving controller.

foot pedal adapter system

The electronic foot-operated water saver brings a whole new level of convenience.